Hey guys got a general question and hoping yall can point me the right way. My 07 WRX motor is out and as I was removing the harness I thought, why don’t I tuck it? I also notice a LOT of blow by and build up on almost every connector.

So my questions are, what would be the best way to clean the harness, extend the length and tuck it so it’s not under my manifold anymore? I don’t normally do anything electrical so this is a new challenge for me. If anyone has done a wire tuck on a Subaru engine, if you can share photos so I have an idea. Either EJ or FA since I have both and can generalize the same idea from FA.

Photos just for yall to see how filthy the harness is hahaha.